Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 9)

Joystick Control

The following applies when configuring a channel for Roboscans only.

When configuring a channel to control a Roboscan you can choose between standard direct

joystick control and joystick acceleration mode (ideal for micro-stepping Roboscans like Pro

218, Pro 518 etc.). The difference between the two modes is that extremely small and

precise movements can be made in acceleration mode while it is still possible to make

bigger movements by holding the joystick in position. The initial movement is very slow to

enable fine adjustment and then the motor speeds up.

To configure a channel for acceleration mode first select a Roboscan when configuring a

channel. You can toggle acceleration mode by using left/right joystick positions. When in

acceleration mode there is a dot shown on the display eg. 10.04 or 10.16.

Basic operation

This section explains how to switch on the Martin 2308 controller, how to use the keys, and

how to select

operation mode

. It also helps you to understand the way the controller

operates.

Switching on

1 First, switch on the Martin 2308 controller by pressing the [on] key, located in the bottom

left hand corner of the front panel.

Because an error-free memory is necessary for the correct functioning of the Martin 2308

controller, various factory-set tests are performed before you will be able to work with it.

Initially {robo} is flashing in the display. Then the version number of the

software

displayed as {rX.XX} where X.XX is the version number. The version number will be

displayed until the memory tests are completed. These tests will last about five seconds.

As soon as the display stops flashing and the version number is displayed you may

perform an

initialization

or a

factory setting

as explained in the Special functions section

of this manual.

If for some reason the memory tests fail, an error message will be displayed. Please

consult the error messages section of this manual for possible ways to continue

operation. If the remaining tests are satisfactory the controller will transmit a

reset

signal

to all Units connected to the link.

If you need to (re)configure the controller for a specific purpose please refer to the section

Factory setting in the Special functions section of this manual.

2 Then, switch on the Units and wait for approximately 1 minute until they have finished

their reset. It is important that you switch on the controller first to ensure that units with

protocol auto-detect function (Martin units that accept both Martin RS-485 and DMX 512

data) select the correct protocol.

Page 10 Version 2.1/3.1 Martin 2308 Controller

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III