Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 21)

Controller. Please note that the complete programmable data memory is transferred from

source to target, completely overwriting the existing memory in the target controller.

The transferal of data between two controllers uses the normal serial transmission link for

communication. Switch off both controllers and connect them using any of the 3 pin XLR

cables that are normally used to connect units. Disconnect the serial link leading to the

fixtures. Whether the input or output connections are used on the controllers is not

important.

1 Switch the target controller on and during the initialization pull the joystick downwards

until the display shows {do00} (Download mode). The target controller is now ready for

receiving data.

2 Switch the source controller on and during the initialization push the joystick upward

until the display shows {up--} (Upload mode). The data transfer will engage

automatically.

During the data transfer the two displays show {UpXX} and {doXX}, respectively, where XX

is a hexadecimal counter. The process will continue until the complete memory is transferred

where after both controllers will display {----}. To reset the controllers to normal operation

you will have to switch them off, and then on. Do not do this however before you have

disconnected the link cable used for transferal as two controllers transmitting on the same

link may cause damage to either or both of the controllers.

If an error message should occur, then consult the "error messages" section of this manual.

Page 22 Version 2.1/3.1 Martin 2308 Controller

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 60 61

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 21