Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 22)

Display messages

Status information

In :

Initialization

. The entire content of the memory is to be deleted.

FAC :

Factory setting

. The restoring to factory-default values is taking place.

ShoX :

show

is about to be edited or deleted. X is a number from 0 to 9.

Shxx :

show

is running. XX is a legal

sequence number

. 1 to 99 for user

sequences

and

A0-A9 B0-B9 C0-C9 D0-D9 for pre-programmed

sequences

Pr : Existing

sequence

show

about to be deleted or edited.

dEl : Delete. Display flashing indicates that a

sequence

show

is to be deleted.

Constant display indicates the deleting phase. Must be confirmed by the user.

SA : Saving

sequence

show

LEXX : Music

trig level

. XX is a number from 1 to 20 level may be changed by user.

SEUP : Setup is saved, refer to Run sequence or Run show.

ShuX :

Shutter

key is pressed, X is selected

strobe rate

On-- :

Shutter

key is pressed and depressed within a second.

Off- :

Shutter

key is pressed and depressed within a second.

SPEX : Speed key is pressed, X is selected movement speed.

YSPX : Speed key is pressed, X is selected movement speed. Y varies depending of the

Unit controlled.

COLX : Color key is pressed, X is selected color number.

YCoX : Color key is pressed. X is selected color number. Y varies depending on the Unit

controlled.

d XX : Dimmer level.

For further status information, please refer to the individual product information in the

appendices A to F.

Error messages

Err0 : FATAL ERROR. The RAM circuit is malfunctioning. Contact your dealer.

Err1 : Memory full. There is no more room for additional scenes.

Err2 : User memory malfunctioning. Contact your dealer.

Err3 : Memory configuration error. The software has detected an inconsistency in the

memory configuration. Please check your programs. If the error persists contact

your dealer.

Err4 : More memory has been added. Shows will be deleted. Confirm by pressing

[enter].

Err5 : If you have upgraded from a version earlier than 1.5, this error will always be

shown when you switch on the first time. Press [enter] to proceed. If this

message appears at any other time it indicates that memory has been removed.

All scenes, sequences and shows will be deleted.

Err6 : Memory full. No room for additional show steps.

Err7 : Memory full. No room for additional scenes or show steps.

Err8 : The maximum number of sequences (99) have already been programmed.

Err9 : Information about sequences in the memory is too damaged to be restored. You

must re-initialize the controller. If this error persists contact your dealer.

ErrA : Wrong memory size. You can only transfer data between controllers with the

Martin 2308 Controller Version 2.1/3.1 Page 23

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III