Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 32)

Roboscan Pro 218

Light On/Off

[shut]

When powering on the Roboscan Pro 218 the lamp itself will

automatically switch on. Press [shut] once to open the shutter,

thereby switching on the light. The status of the display changes to

{On--}, thus indicating that the light is now on.

[shut]

Press [shut] again to switch the light back off. The status of the

display now changes to {OFF-}, thus indicating that the light is now

off. Please note that the lamp itself remains on.

Strobing

[shut] +

[up]/

[down]

To program a strobe effect, press the [shut] key, and keep it

pressed, whilst moving the joystick up or down to change the strobe

rate. The status of the display changes to {ShuX} where X is a

number between 0 and 6 indicating the strobe rate. As you move

the joystick up and down, you will see that X changes accordingly.

{Shu0} indicates that the strobe is disabled. {Shu6} is the slowest

strobe rate.

Dimmer - Light intensity

[dimmer]

Press [dimmer] once to access the dimmer function. The status of

the display now changes to {d XX}, where XX is a number between

00 and 31 indicating the dimming level.

{d 31} is no dimming (full light} and {d 00} is full dimming (no light).

If you are using a 2208 controller the [dimmer] key is not printed on

the front panel but is located ’invisibly’ just to the right of the [shut]

key.

[up]/

[down]

Now, move the joystick up and down to set the desired light

intensity. As you move the joystick you will see that the display

changes between {d 00} and {d 31}, as an indication of the

programmed intensity.

[dimmer]

Press [dimmer] again to quit the dimmer setting.

Martin 2308 Controller Version 2.1/3.1 Page 33

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 60 61

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 32