Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 57)

APPENDIX F - Programming the 516 Dimmer Controller

Each Martin dimmer controller is able to control 16 individual 0-10 V outputs at 16 different

levels.

One Dimmer controller can be controlled per channel of the 2308 controller.

Output Level

[color]

Press [color] to program the output level of the analogue outputs.

The display then changes to {CCXX} where CC indicates the

channel number, 1 to 16, and XX is a number between 0 and 15

indicating the output level.

[left]/

[right]

Move the joystick left or right to change the channel number. You

will see that the status of the display changes accordingly.

[up]/

[down]

Then, move the joystick up or down to change the output level. You

will see that the status of the display changes accordingly.

[shut]

You can press [shut] if you wish to set a channel to full output.

[color]

Press [color] again to quit the output setting.

Please note that you will still be able to set the level of the last

programmed analog channel. This is very useful in follow mode if

you have a Martin smoke machine connected to the dimmer

controller and you need some smoke while your shows are running.

Just set the channel into follow mode - push the joystick up to start

the smoke machine running and then pull it down again when you

have enough smoke - then release the channel again. In this way

you may remote-control one or more Martin smoke machines from

the 2308 controller - you may even program smoke-output into your

sequences. Be careful, however, as the smoke output depends on

the trig rate used.

Page 58 Version 2.1/3.1 Martin 2308 Controller

1 2 ... 52 53 54 55 56 57 58 59 60 61

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 57