Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 46)

Robocolor Pro 400

Lamp On/Off and Light On/Off

[shut]

When powering on the Robocolor Pro 400 the lamp itself will remain

off until a ’lamp on’ command is sent from the controller. Press

[shut] once to ignite the lamp. The status of the display then

changes to {On--}, indicating that the lamp is now on. This key-press

also opens the shutter.

[shut]

Press [shut] again to close the shutter, thereby switching off the

light. The status of the display then changes to {OFF-} Pressing

[shut] again toggles the light between on and off. Please note that

the lamp itself remains on.

[shut]

t>8 sec.

To power the lamp back off again, keep the [shut] key pressed for

about 8 seconds until the status of the display changes to {LOFF}.

Please note that the Roboscan Pro 518 uses a cold restrike lamp,

meaning that you must wait approximately 5 minutes before you can

power it back on again.

Strobing

[shut] +

[up]/

[down]

To program a strobe effect, press the [shut] key, and keep it

pressed, whilst moving the joystick up or down to change the strobe

rate. The status of the display changes to {ShuX} where X is a

number between 0 and 6 indicating the strobe rate. As you move

the joystick up and down, you will see that X changes accordingly.

{Shu0} indicates that the strobe is disabled. {Shu6} is the slowest

strobe rate.

Dimmer - Light intensity

[dimmer]

Press [dimmer] once to access the dimmer function. The status of

the display now changes to {d XX}, where XX is a number between

00 and 88 indicating the dimming level.

{d 00} is no dimming (light full on} and {d 88} is full dimming (black-

out). If you are using a 2208 controller the [dimmer] key is not

printed on the front panel but is located ’invisibly’ just to the right of

the [shut] key.

[up]/

[down]

Now, move the joystick up and down to set the desired light

intensity. As you move the joystick you will see that the display

changes between {d 00} and {d 88}, as an indication of the

programmed intensity.

[dimmer]

Press [dimmer] again to quit the dimmer setting.

Martin 2308 Controller Version 2.1/3.1 Page 47

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III