Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 7)

The following instructions describe how to make a proper serial data link:

1 Connect the output of the 2308 Controller to the data input of the first Unit, using the

XLR-XLR cable that came with the controller. Additional cables can be supplied by your

Martin dealer. Alternatively, you can use standard balanced microphone XLR-XLR cables.

2 Connect the output of the first Unit to the input of the next, again using a XLR-XLR cable.

Continue this way until all Units are connected. The order, in which you connect the Units,

is not important and has no effect on programming as far as the controller is concerned -

use an order which gives the easiest and shortest cable routing.

3 Finally, insert the XLR

terminating-plug

, that came with the controller, into the free output

socket of the last Unit on the

link

. It’s important to insert this plug to ensure correct and

error-free

communication

between the Martin 2308 controller and the Units.

Addressing the Units

Please refer to Appendix A when setting the address on each individual Unit on the

link

setting the

DIP switch

. The address that is given to the Unit decides which

channel

to select

on the controller in order to program that particular Unit. In order to control each unit

individually each must have its own individual address.

Connecting an audio source

If you wish to trigger some of your sequences from the beat of the music then connect your

audio source to the 6.35mm (1/4 inch) mono jack-socket on the rear of the controller. The

audio source you connect, should provide a line level signal (775mV RMS).

Rear panel connections

Page 8 Version 2.1/3.1 Martin 2308 Controller

1 2 3 4 5 6 7 8 9 10 11 12 ... 60 61

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 7