Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 35)

Roboscan Pro 518

Lamp On/Off and Light On/Off

[shut]

When powering-on the Roboscan Pro 518 the lamp itself will remain

off until a ’lamp on’ command is sent fro the controller. Press [shut]

once to ignite the lamp. The status of the display then changes to

{on--}, thus indicating that the lamp is now on. This key-press also

opens the shutter.

[shut]

Press [shut] again to close the shutter, thereby blanking off the light.

The status of the display then changes to {OFF-} Pressing [shut]

further times toggles the light between on and off. Please note that

the lamp itself remains on.

[shut]

t>8 sec.

To power the lamp back off again, keep the [shut] key pressed for

about 8 seconds until the status of the display changes to {LOFF}.

Please note that the Roboscan Pro 518 uses a cold restrike lamp,

meaning that you’ll have to wait approximately 5 minutes before you

can power it back on again.

Strobing

[shut] +

[up]/

[down]

To program a strobe efect, press the [shut] key, and keep it

pressed, whilst moving the joystick up or down to change the strobe

rate. The status of the display changes to {ShuX} where X is a

number between 0 and 6 indicating the strobe rate. As you move

the joystick up and down, you will see that X changes accordingly.

{Shu0} indicates that the strobe is disabled. {Shu6} is the slowest

strobe rate.

Dimmer - Light intensity

[dimmer]

Press [dimmer] once to access the dimmer function. The status of

the display now changes to {d XX}, where XX is a number between

00 and 31 indicating the dimming level.

{d 00} is no dimming (full light} and {d 31} is full dimming (no light).

If you are using a 2208 controller the [dimmer] key is not printed on

the front panel but is located ’invisibly’ just to the right of the [shut]

key.

[up]/

[down]

Now, move the joystick up and down to set the desired light

intensity. As you move the joystick you will see that the display

changes between {d 00} and {d 31}, as an indication of the

programmed intensity.

[dimmer]

Press [dimmer] again to quit the dimmer setting.

Page 36 Version 2.1/3.1 Martin 2308 Controller

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III