Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 18)

Trig sources

To run a

sequence

or a

show

a signal is needed to tell the controller when to continue from

one

scene

to the next. This signal is called a

trig source

There are three basic trig sources:

Manual trig

Auto trig

and

Music trig

These functions are accessed by pressing [man], [auto] or [music], respectively. One, two

or all

trig sources

may be selected at the same time. This will be explained in detail later in

this section.

Manual trig

manual trig

is selected then - when tapping the button marked [trig] - the controller will

step through each of the

scenes

in the selected

sequence

. If (manual) is on, tapping [trig]

always overrides

auto-

and

music trig

Auto trig

The

auto trig

function has two modes of operation:

To select the first mode, press [auto] and (auto) will be continuously on. The

trig rate

with

which a

sequence

has been programmed is used.

To select the second trig mode, press [auto] again and (auto) starts flashing. The

trig rate

is ’frozen’ to the current rate and will use this rate for the following

sequences

and

shows

until [auto] is pressed again. It is possible to tap [trig] at a particular rate in both modes (two

to three times are sufficient) and the controller will continue with this new

trig rate

. The rate

is the period of time between 2 consecutive pushes of the trig button.

When setting the

autotrig rate

it can be a little difficult to hit the desired rate accurately. It

is possible to fine-tune the

trig rate

by moving the joystick up to increase or down to

decrease the rate. This is not possible when Units are being used as follow-spots or if (level)

is on.

Setting the

autotrig rate

when (man) is on is not possible because tapping the [trig] button

is used to override the

auto trig

function.

If only Manual Trig is selected, then pressing [auto] will automatically swap the mode to

Auto-Trig and de-select [man] turning (man) off.

Martin 2308 Controller Version 2.1/3.1 Page 19

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III