Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 30)

Strobing (gobo strobe)

[shut] +

[up]/

[down]

The gobo wheel can be used to create strobe effects. First, select a

gobo as described above. Then, whilst keeping the [shut] key

pressed, move the joystick up and down. The Roboscan 812 will

now strobe (switch) between the selected gobo and the one just

before this. As you move the joystick up and down you will see that

the display changes between {Shu0} and {Shu7}, thus indicating the

strobe rate. {Shu0} indicates that the strobe is disabled. {Shu7} is

the slowest strobe rate.

Movement

[up]/

[down]/

[left]/

[right]

Mirror positions are programmed when no other programmable

feature is selected. That is when the display shows the current

sequence and scene number. To program a movement simply move

the joystick up, down, left and right. If you have configured the

controller with acceleration factor during the set-up, you will see

that, when moving the joystick in one direction and keeping it there,

the mirror starts moving with a slow speed and then accelerates

until full speed is obtained. This feature allows you to program

accurate positions in a quick way.

Movement, Color and Gobo Speed

[speed]

Press [speed] to access the movement speed setting. The status in

the display now changes to {SPEX}, where X is a number between

1 and 8 indicating the movement speed.

[up]/

[down]

Move the joystick up or down to change the movement speed. You

will see that the status of the display changes accordingly.

[speed]

Press [speed] another time to access the color speed setting (the

speed at which the color wheel scrolls from one color to another).

The status in the display now changes to {CSPX}, where X is a

number between 1 and 8 indicating the speed.

[up]/

[down]

Move the joystick up or down to change the color speed. You will

see that the status of the display changes accordingly.

[speed]

Press [speed] a third time to access the gobo speed setting (the

speed at which the gobo wheel scrolls from one gobo to another).

The status in the display now changes to {GSPX}, where X is

number between 1 and 8 indicating the speed.

[up]/

[down]

Move the joystick up or down to change the gobo speed. You will

see that the status of the display changes accordingly.

[speed]

Finally, press speed once again to quit the speed setting.

Martin 2308 Controller Version 2.1/3.1 Page 31

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III