Martin RoboColor III Betriebsanweisung PDF herunterladen (Seite 29)

Roboscan 812

Lamp On/Off

[shut]

When powering-on the Roboscan 812 the lamp itself will remain off

until a ’lamp on’ command is sent fro the controller. Press [shut]

once to ignite the lamp. The status of the display then changes to

{on--}, thus indicating that the lamp is now on. Please note that the

color and gobo wheels in the Roboscan 812 black-out as default

positions. To enable light output both color and gobo must be

moved from default position. See below.

[shut]

t>8 sec.

To power the lamp off again, keep the [shut] key pressed for about

8 seconds until the status of the display changes to {LOFF}. Please

note that the Roboscan 812 uses a cold restrike lamp, meaning that

must wait approximately 3 minutes before you can power it back on

again.

Colors

[color]

Press [color] once to access the color setting. The status of the

display now changes to {Co_X}, where X is a number between 1

and 13, indicating the selected color.

[up]/

[down]

Move the joystick up or down to change the color. You will see that

the status of the display changes accordingly.

[left]/

[right]

Move the joystick left or right to split the beam into two neighbouring

colors. The display shows the nearest color.

[color]

Press [color] again to quit the color setting.

Gobos

[gobo]

Press [gobo] once to access the gobo setting. The status of the

display now changes to {Go_X}, where X is a number between 1

and 13, indicating the selected gobo.

[up]/

[down]

Move the joystick up or down to change the gobo. You will see that

the status of the display changes accordingly.

[left]/

[right]

Move the joystick left or right to split the beam into two neighbouring

gobos. The display shows the nearest gobo.

[gobo]

Press [gobo] again to quit the gobo setting.

Page 30 Version 2.1/3.1 Martin 2308 Controller

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin RoboColor III Betriebsanweisung Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin RoboColor III