Martin MX SERIES Bedienungsanleitung PDF herunterladen (Seite 9)

MX-1 user manual Installation 9

NSTALLATION

The MX-1 can be fastened directly to a suitable surface or to a rigging clamp by

means of its adjustable mounting bracket and it can be placed at an angle directly

on the stage or floor using the mounting bracket as a floor stand.

Do not lay the fixture flat on its pan/tilt arms. For maximum lamp life, do not

place the fixture directly on or beside a speaker cabinet or other source of strong

vibrations.

Warning! Block access below the work area before proceeding.

Warning! Always use a secure means of secondary attachment.

To rig the MX-1

1 Verify that the clamp (not included) is undamaged and can bear at least 10

times the fixture’s weight. Bolt the clamp securely to the bracket with a grade

8.8 (minimum) M12 bolt and lock nut, or as recommended by the clamp

manufacturer, through the 13 mm hole in the center of the mounting bracket.

2 If permanently installing the fixture, verify that the hardware (not included)

and mounting surface can bear at least 10 times the fixture’s weight. The four

6.2 mm holes and/or the 13 mm hole in the mounting bracket may be used.

3 Verify that the structure can support at least 10 times the weight of all

installed fixtures, clamps, cables, auxiliary equipment, etc.

4 Working from a stable platform, clamp or fasten the fixture to the structure.

5 Install a safety cable that can hold at least 10 times the weight of the fixture

through/over the support and through a hole in the pan/tilt arm.

6 Loosen the swivel locks and tilt the fixture to the desired angle. Turn the

swivel locks clockwise to tighten. If a swivel lock does not tighten fully, pull

the handle out, turn it counterclockwise, and retighten. Repeat as necessary.

7 Verify that the fixture is located at least 0.3 meters (12 in.) away from the

surface to be illuminated and at least 0.1 meters (4 in.) from any combustible

materials. Verify that the clearance around the fan and air vents is at least 0.1

meters (4 in.). Verify that there are no flammable materials nearby.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Martin MX SERIES Bedienungsanleitung Seite 9