Martin MX SERIES Bedienungsanleitung PDF herunterladen (Seite 6)

6 Lamp MX-1 user manual

AMP

The MX-1 comes from the factory with a Philips 500 hour lamp installed. This a

24V, 250W ELC halogen lamp. A high-output 50 hour lamp from Osram is also

available. Installing any other lamp may damage the fixture!

Allow the lamp to cool for at least 5 minutes before packing and moving the

fixture. To avoid possible damage, remove the lamp when shipping the fixture.

There are two lamp intensity options that may be selected with DIP-switch pin 12.

Set pin 12 to ON for reduced lamp voltage and longer lamp life or to OFF for full

intensity.

Warning! Always disconnect the fixture from AC power if the lamp

blows. Allow the fixture to cool for 5 minutes before installing

a new lamp.

To install a lamp in the MX-1

1 Disconnect the fixture from AC power. If replacing a hot lamp, allow it to cool

for 5 minutes before removing the cover. The lamp cools faster with the cover

in place.

2 Remove the 4 cover screws and lift off the cover.

3 To remove the lamp, grasp it by the reflector and pull it out of the holder. Pull

the socket straight back off the metal pins. Do not pull the wires.

4 Push the socket fully onto the pins of the new lamp.

5 Gently push the lamp into the holder until it snaps into place.

6 Replace the top cover.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Keine Kommentare

Martin MX SERIES Bedienungsanleitung Seite 6