Martin MX SERIES Bedienungsanleitung PDF herunterladen (Seite 15)

MX-1 user manual DMX operation 15

DMX

OPERATION

DMX MODES

The MX-1 has 3 DMX modes to choose from: a 1-channel mode that provides

control of the built-in stand-alone features, a 6-channel mode that provides

position control of all effects plus speed control of the mirror, and an “extended”

7-channel mode that in addition provides speed control of the effect wheel.

To select DMX mode

1 Disconnect the fixture from power.

Set DIP-switch pin 10 to OFF.

2 To select 1-channel DMX mode, set DIP-switch pin 11 to ON.

3 To select 6-channel DMX mode, set DIP-switch pin 11 to OFF. Verify that the

6/7 ch. jumper is set for 6 channels. This is the factory configuration. See

“Setting the 6/7-ch. DMX jumper” on page 19.

4 To select 7-channel DMX mode, set DIP-switch pin 11 to OFF. Set the 6/7 ch.

jumper for 7 channels as described on page 19.

DMX ADDRESS

DIP-switch pins 1-9 are used to set the control address. The address, also known

as the start channel, is the first channel used to receive instructions from the

controller.

For independent control, each fixture must be assigned its own address and non-

overlapping control channels. Two MX-1s may share the same address only if

they are to respond identically: they will receive the same instructions and

individual control will not be possible.

To select DMX address

1 Select an address for the fixture on your controller. Look up the DIP-switch

setting for the address in the DIP-switch settings table below.

2 Disconnect the fixture from power.

3 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Keine Kommentare

Martin MX SERIES Bedienungsanleitung Seite 15