Martin MX SERIES Bedienungsanleitung PDF herunterladen (Seite 12)

12 Stand-alone operation MX-1 user manual

TAND

ALONE

OPERATION

The MX-1 may be operated without a controller in stand-alone mode. It may be

operated as a single unit or together with other MX-1s in “master/slave”

configuration.

Several options are available to modify stand-alone operation. These options are

selected using the DIP-switch as described below.

Important! The MX-1 transmits a signal when DIP-switch pins 2 and 10 are

set to ON. To avoid damage to the electronics, connect no

more than 1 transmitting device (master or controller) to the

data link.

SINGLE UNIT OPERATION

The fixture defaults to stand-alone mode with music trigger whenever power is

applied and there is no control signal. Options for trigger type, mirror speed and

movement range, and lamp intensity may be selected as described under “Stand-

alone settings”.

MASTER / SLAVE OPERATION

Multiple MX-1s can be connected together, without a controller, for synchronized

“master/slave” operation in which the slaves mimic the behavior of the master.

To connect units for master / slave operation

1 Connect the output of one MX-1 to the input of the next MX-1.

2 Connect additional MX-1s output to input. Up to 32 may be connected.

3 Terminate the link on both ends by inserting a

female

termination plug into

the data

input

of the first fixture and a

male

termination plug into the data

output

of the last fixture. (The female terminator may not be required if the

first fixture is the master.) A termination plug is simply an XLR connector with

a 120 ohm, 0.25 W resistor soldered across pins 2 and 3.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Martin MX SERIES Bedienungsanleitung Seite 12