Martin MAC 600E Bedienungsanleitung PDF herunterladen (Seite 23)

Updating software

PDATING

SOFTWARE

The latest software and documentation for the MAC 600 (E) NT is available from the Martin Professional web site.

Software installation requires a Martin uploader, such as the MPBB1, prepared with the latest fixture software. The

DMX interface card provided with the Club version of the Martin LightJockey controller also supports software

upload.

To install software with the MPBB1 uploader, normal method

1 Download the latest MAC 600 (E) NT CPU firmware from the Martin web site at http://www.martin.dk. Load

the software into the uploader as described in the MPBB1 manual.

2 Connect the uploader to the fixture as you would a controller.

The data link must be terminated.

Apply power

to the uploader and the fixtures.

3 After the fixture has finished resetting, select

UPLd from the MPBB1 menu and press [ENTER]. Select

dMX and press [ENTER].

4 Wait. The software has been installed when the MPBB1 displays

dONE and the fixtures reset. Turn off and

disconnect the MPBB1.

5 If a check-sum error occurs and/or the fixture does not reset, data was interrupted or corrupted during

transmission. Reattempt the upload using backup method I.

To install software with the MPBB1, backup method I

Follow this procedure to install software if a normal upload attempt is unsuccessful.

1 Disconnect the fixture from power: it must be off at least 10 seconds.

Do not apply power to the fixture until

the uploader is connected and ready.

2 Connect the uploader to the fixture as you would a controller.

Terminate the link

3Select UPLd from the uploader menu and press [ENTER]. Select boot

but do not press [ENTER].

4 Apply power to the fixture.

5 When the fixture display reads

boot, press [ENTER] on the uploader. If the fixture display shifts between

CSER and boot, press [ENTER] 5 seconds after the display changes to boot. The timing must be

exact.

6 Wait. When the fixture resets, the software has been installed successfully. Disconnect the uploader.

To install software with the MPBB1, backup method II

Use this procedure to install software if all else fails or if a boot sector upload is recommended in the update notes.

1 Disconnect the fixture from power.

2 Remove the printed circuit board and move the boot

sector jumper to the boot setting. Reconnect any

unplugged wires.

3 Connect the uploader to the fixture as you would a

controller.

Terminate the link

4Select UPLd from the uploader menu and press [ENTER]. Select boot.

Do not press [ENTER].

5 Apply power to the fixture and wait 5 seconds. Press [ENTER] on the uploader.

6 Wait. The software has been installed when the fixture resets.

7 Disconnect the fixture from power, move the jumper back to the normal setting, and replace the circuit

board.

PL121

INIT

PL121

INIT

normal settingboot setting

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 600E Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Martin MAC 600E