Martin MAC 250+ Bedienungsanleitung

MAC 250 Krypton/Entouruser manual

10 MAC 250 Krypton/EntourTIPS FOR BUILDING A SERIAL LINK • Use shielded twisted-pair cable designed for RS-485 devices: standard microphone cable can

Control Panel 11CONTROL PANELYou set the address and personalities, read out data, and execute service utilities from the control panel.Settings can

12 MAC 250 Krypton/Entour• , the shortcuts setting which can be found under the PERS (personality) menu, determines whether the color and gobo wh

Control Panel 13FIRMWARE VERSION→ displays the firmware version number. The firmware version is also displayed briefly atstartup. Test and ser

14 MAC 250 Krypton/EntourDMX-512 CONTROLThe MAC 250 Krypton/Entour is compatible with USITT DMX512 controllers. The full protocol is available in “DM

DMX-512 control 15angle or rotation speed are selected on channel 5 (channel 7 in 16-bit Extended mode). Fine tuning of thisindex position or rotatio

16 MAC 250 Krypton/Entourdoes not offer cross-fade speed control. Vector control also provides smoother movement, particularly atslow speeds, with co

Optical configuration 17OPTICAL CONFIGURATIONGOBO ORIENTATIONThe orientations shown in Figure 3 are correct in most cases, but consult your Martin de

18 MAC 250 Krypton/EntourCUSTOM GOBOSCustom glass gobos for the MAC 250 Krypton/Entour should be made so that the artwork is reversed whenviewed from

Optical configuration 19REPLACING A GOBODanger! Intense heat. Avoid contact by persons and materials. The exterior of the fixture can get very hot -

All measurements are expressed in millimeters393375538469364119315270°270°560270°128.5°128.5°© 2004-2005 Martin Professional A/S, Denmark. All rights

20 MAC 250 Krypton/Entour7. Insert the gobo holder back in the gobo wheel using a small flathead screwdriver to lift the retainingblades.8. Replace t

Optical configuration 212. Remove the top cover of the fixture head using a flathead screwdriver to loosen the four quarter-turnscrews. The top and b

22 MAC 250 Krypton/EntourColor filtersSTANDARD CONFIGURATIONThe MAC 250 Krypton/Entour provides 12 dichroic color filters as shown below. REPLACING A

Optical configuration 233. Turn the color wheel to access the desired color filter. Press thefilter forwards slightly to release it and then grasp it

24 MAC 250 Krypton/Entour3. Using a flathead screwdriver, remove the two retaining plates (only one - at position A - is illustratedhere) holding the

Optical configuration 25REPLACING THE PRISM IN A MAC 250 KRYPTONDanger! Intense heat. Avoid contact by persons and materials. The exterior of the fix

26 MAC 250 Krypton/Entour5. Using a Philips screwdriver, remove the half-circle shaped plate that holds the prism into place (asindicated in this ill

Optical configuration 27cover is found by checking if the text on the back of the head is oriented correctly (top) or not (bottom) asillustrated here

28 MAC 250 Krypton/Entour5. Remove the four Phillips screws.6. Lift the lens module plate off the effect module.7. Remove the three Torx 10 screws ho

Service 29SERVICEThe MAC 250 Krypton/Entour requires regular maintenance to maintain peak performance. Excessive dust,grease, and smoke fluid buildup

CONTENTSINTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5Features. . . . . . . . .

30 MAC 250 Krypton/Entourpower and allow it to cool for at least 45 minutes before proceeding. Wear safety goggles to protect your eyes. 1. Locate th

Service 312. Wash dirty lenses and filters with isopropyl alcohol 99.9%. A generous amount of regular glass cleanermay also be used, but no residues

32 MAC 250 Krypton/Entour4. Re-attach the yoke cover.Have the fixture serviced by a Martin service technician if fuses blow repeatedly.Updating softw

DMX protocol 33DMX PROTOCOLThis chapter contains:• “MAC 250 Krypton DMX protocol” on page 34• “MAC 250 Entour DMX protocol” on page 37

34 MAC 250 Krypton/EntourMAC 250 Krypton DMX protocol16 Bt(16 Bit Mode)16 Ex(16 Bit Extended) Value Percent Function11If DMX Reset is disabled in the

DMX protocol 3550 - 255 0 - 100Color (Least Significant Byte) 460 - 45 - 1011 - 1516 - 2021 - 2526 - 3031 - 3536 - 4243 - 5051 - 5859 - 6566 - 7374 -

36 MAC 250 Krypton/Entour9120 - 255 0 - 100PanLeft → right (128 = neutral)10 130 - 255 0 - 100Pan fine (Least Significant Byte) Left → right11 140 -

DMX protocol 37MAC 250 Entour DMX protocol16 Bt(16 Bit Mode)16 Ex(16 Bit Extended) Value Percent Function11If DMX Reset is disabled in the menu, a re

38 MAC 250 Krypton/Entour50 - 255 0 - 100Color fine (Least Significant Byte) 460 - 45 - 1011 - 1516 - 2021 - 2526 - 3031 - 3536 - 4243 - 5051 - 5859

DMX protocol 39790 - 78 - 1516 - 2324 - 3132 - 3940 - 4748 - 5556 - 6364 - 7172 - 7980 - 8788 - 9596 - 105106 - 115116 - 125126 - 135136 - 145146 - 1

4 MAC 250 Krypton/EntourThis page left intentionally empty.

40 MAC 250 Krypton/Entour15 180 - 2 3 - 245246 - 251252 - 2550 - 2 3 - 245246 - 248249 - 251252 - 2550 - 245246 - 248249 - 251252 - 2550 - 2 3 - 2452

Control menu 41CONTROL MENUOptions displayed in bold represent the default settings.Note that lowercase letters in the control panel display are bein

42 MAC 250 Krypton/Entour→Hours of operation since counter reset. To reset, display counter and press [up] for 5 seconds.Total ho

Control menu 43Reset fixtureLamp onLamp offOpen shutterClose shutterFast strobeMedium strobeSlow strobe-

44 MAC 250 Krypton/Entour(Press and hold Enter more than 3 sec. to access) Magnetic sensors monitor the positions of the color wheel, gobo

Error messages 45ERROR MESSAGESDisplay readout Appears if... What to do (Memory error)...the EEPROM memory cannot be read. • Contact service tech

46 MAC 250 Krypton/EntourTROUBLESHOOTINGProblem Probable cause(s) RemedyOne or more of the fixtures is completely dead.No power to fixture.• Check th

Circuit board connections 47CIRCUIT BOARD CONNECTIONS33120043-BTemp HeadTemp HeadLight SensorLight Sensor14 1513TiltF.B.TiltF.B.PanF.B.PanF.B.Temp On

SPECIFICATIONS - MAC 250 KRYPTONPHYSICALBase length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

THERMALMaximum ambient temperature (Ta) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40° C (104° F)Maximum s

Introduction 5INTRODUCTIONThank you for selecting the Martin MAC 250 Krypton or the MAC 250 Entour. FeaturesSome of the many features include: • effi

SPECIFICATIONS - MAC 250 ENTOURPHYSICALBase length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

TYPICAL POWER AND CURRENT100 V, 50 Hz* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Gradav Hire and Sales LtdUnit C6 Hastingwood Trading EstateHarbet Road London N18 3HUPhone 020 8803 7400 FAX 020 8803 5060email [email protected]

6 MAC 250 Krypton/Entour• Do not expose the fixture to rain or moisture. • Refer any service operation not described in this manual to a qualified te

Setup 7SETUPUnpackingThe MAC 250 Krypton/Entour comes with:• MSD 250/2 lamp (factory installed)• 3-meter, 3-wire IEC power cable• user manual• 1/4-tu

8 MAC 250 Krypton/Entour2. Remove the 2 Phillips screws in the access cover directly behind the power and data connectors. Lift offthe cover. 3. Loca

Setup 9The MAC 250 Krypton/Entour includes an omega clamp mounting bracket to which 1 or 2 rigging clamps(not included) can be bolted. The clamp moun