Martin MAC 600E Bedienungsanleitung PDF herunterladen (Seite 14)

MAC 600 (E) NT

Tests and readouts

The following readouts and tests are available from the control panel.

To calibrate temperature sensors

The temperature sensors are calibrated at the factory. Use this procedure if you suspect the calibration is faulty.

1 Turn off the fixture for 4 hours to allow it to cool to room temperature.

2 Measure the room temperature in Celsius. (To convert F° to C°, subtract 32° and multiply by 0.555.)

3 Power up the unit and allow it to reset.

4 Press [MENU] and [↓] and hold until “25” is displayed.

5 Scroll to the room temperature and press [ENTER].

Function Path Options Readout or effect

Usage counters

TIME/

Po H

Total hours of operation since fabricated.

RPoH

Hours of operation since counter reset. To reset, display

counter and press [↑

]

for 5 seconds.

LA H

Total hours of operation with lamp on since fabricated.

RLAH

Lamp hours since counter reset. Reset when relamping to

track lamp life. To reset, display counter and press [↑

]

for 5

seconds.

LSTR

Total number of lamp strikes since fabricated.

RSTR Number of lamp strikes since counter reset. To reset, display

counter and press [↑

]

for 5 seconds.

DMX readout

dMXL/

STCO

Decimal value of the DMX start code. The start code must be

0 for the MAC 600 (E) NT to function properly.

CH 0..CH14

DMX value (from 0 - 255) received for each channel. Note

that the channel number is 1 less than it is in the DMX

protocol.

Software versions

Ver/

CPU

CPU firmware version. Updates can be uploaded.

FEBA

Feedback circuit firmware version.

dISP

Display circuit firmware version.

Temperature readout

SPEC/TEMP/

HEAd

Head temperature in Celsius. Temperatures below 25° C are

shown as

-25; temperatures above 100° C are shown as

+100.

bASE

Base temperature in Celsius. Temperatures below 25° C are

shown as

-25; temperatures above 100° C are shown as

+100.

Tests

TSEQ RUN

Run a general test of all effects

SPEC/PCbT T1-T3

Run three tests of the circuit board.

For service use only.

SPEC/FTST/

WTST

Run an quality control effects test

MTST

Run a quality control movement test

SPEC/FTST/

STST

dIM

Run a quality control dimmer sensor test

COL

Run a quality control color wheel sensor test

Run a quality control beam shaper sensor test

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 600E Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Martin MAC 600E