Martin MAC 2000 Wash Bedienungsanleitung PDF herunterladen (Seite 14)

14 MAC 2000 Wash

positions at a steady rate. Begin by selecting the alternative, MOd2, which is better if the intermediate positions stray

significantly from the line of travel.

The second parameter is the number of position updates used to calculate speed. The level is adjustable between 1 and

10 under

PERS/TRAC/CAL. Increasing the number of samples increases the distance over which speed is

calculated, making movement smoother but less responsive to sudden changes. Experiment for best results.

DISPLAY

The display intensity (dINT) setting controls display brightness. The display on/off setting (dISP) determines

whether the display remains on or extinguishes two minutes after the last key-press. To flip the display, press [Up] and

[Down] simultaneously.

LAMP

There are two settings that modify lamp control: Automatic Lamp On (ALON) and DMX Lamp Off (DLoF).

When ALON is off, the lamp remains off until a “lamp on” command is received from the controller. When ALON is

on, the lamp strikes automatically after the fixture is powered on. When

ALON is set to DMX, the lamp strikes

automatically when the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.

When

ALON is set to either ON or DMX, the automatic lamp strike timing is staggered to prevent all lamps from

striking at once. The delay is determined by the fixture address.

If striking lamps from the controller, note that striking many lamps at once may cause a voltage drop large enough to

prevent lamps from striking or trip the main circuit breaker. Avoid this by programming a “lamp on” sequence that

strikes lamps one at a time at 5 second intervals.

Power to the lamp can be turned off from the controller if DMX Lamp Off (

dLOF) is on.

DMX RESET

The fixture can be reset from the controller if DMX reset (PERS/dRES) is ON.

CUSTOM SETTINGS

The custom configuration function allows you to save and recall three sets of fixture settings. The savable settings are

DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp off and reset, display settings, shortcuts, studio

mode, automatic lamp on, effects feedback, tracking algorithm, and tracking samples.

Readouts

Note: The MP-2 Uploader provides commands to display the time, temperature, and version readouts on the fixture

control panel.

TIME

INFO/TIME

provides readouts of fixture hours (HRS), lamp hours (L HR), and lamp strikes (L ST). Under

each item is a resettable (

RSET) increment counter and a non-resettable counter for total accumulated hours/strikes

since fabrication (

TOTL). To reset an increment counter, display it and then press [Up] until it reads 0. (This may also

be done remotely using the MP-2 Uploader.)

TEMPERATURE

INFO/TEMP

provides readouts of the head and base temperature in Celsius and Fahrenheit.

FIRMWARE VERSION

INFO/VER

displays the version number of the installed firmware. The firmware version is also displayed briefly at

startup.

DMX

The DMXL menu shows the DMX start code (STCO) and DMX values received for each effect.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 2000 Wash Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin MAC 2000 Wash