Martin CX-2 Bedienungsanleitung PDF herunterladen (Seite 14)

14 Data connection CX-2 user manual

To connect the data link

1 Connect a data cable to the controller’s data output. If controller has a 5-pin

output, use a 5-pin male to 3-pin female adaptor cable (P/N 11820005).

2 Lead the data cable from the controller to the first fixture. Plug the cable into

the fixture’s data input.

3 Connect the output of the fixture closest to the controller to the input of the

next fixture. If connecting to a fixture with reversed-polarity (pin 3 cold),

insert a phase-reversing cable between the two fixtures.

4 Continue connecting fixtures output to input. Up to 32 devices may be

connected on a serial link.

5 Terminate the link by inserting a male termination plug (P/N 91613017) into

the data output of the last fixture. A termination plug is simply an XLR

connector with a 120 ohm, 0.25 W resistor soldered across pins 2 and 3.

Male XLR

Male

P/N 91613017

120

Female XLR

Female

120

Termination PlugTermination Plug

P/N 91613018

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Martin CX-2 Bedienungsanleitung Seite 14