Martin MAC 300 Bedienungsanleitung PDF herunterladen (Seite 13)

Fixture Settings

Readouts

The MAC 300 has counters to track usage, maintenance intervals, lamp life, etc. One set of counters shows total

(

TOTL

) accumulated usage and cannot be reset. Another set shows usage since the counter was reset (

RSET

). To

reset one of these counters, navigate to the readout and press

[

↑

]

for 5 seconds.

Hours used

To read the accumulated total number of hours the fixture has been on, navigate to

INFO

HRS

TOTL

and press

[Enter]. To read the number of hours since the counter was last reset, navigate to

INFO

HRS

RSET

and press

[Enter]. To reset this counter, navigate to the readout and press

[

↑

]

for 5 seconds.

Lamp hours

To read the accumulated total number of lamp hours, navigate to

INFO

TOTL

and press [Enter]. To read

the number of lamp hours since the counter was last reset, navigate to

INFO

RSET

and press [Enter]. To

reset this counter when installing a new lamp, navigate to the readout and press

[

↑

]

for 5 seconds.

Lamp strikes

To read the accumulated total number of lamp strikes, navigate to

INFO

TOTL

and press [Enter]. To read

the number of lamp strikes since the counter was last reset, navigate to

INFO

RSET

and press [Enter]. To

reset this counter when installing a new lamp, navigate to the readout and press

[

↑

]

for 5 seconds.

Software version

Navigate to the sub menu under

INFO

VER

to read the version number of the CPU software (

CPU

), feedback cir-

cuit software (

FEBA

), and display module software (

dISP

Utilities

Upload mode

The software upload mode is engaged automatically by the MPBB1 Uploader. Engage upload mode manually only if

automatic upload fails. To do so, navigate to

UTIL

UPLd

and press [Enter]. Press [Enter] again when

SURE

displayed to confirm, or press [Menu] to escape. See also “Updating software” on page 19.

Demonstration program

The demonstration menu allows you to run a preprogrammed stand-alone program. Before running the demo, set the

minimum and maximum pan and tilt positions (

MINP

MAXP

MINT

MAXT

) to a good location for viewing the

effects. Select

and press [Enter] to run the demo. Press [Menu] to stop the program.

Test programs

Test sequence

Navigate to

TEST

TSEQ

and press [Enter] when

RUN

is displayed to perform a general fixture test. Press [Menu]

to stop the program.

DMX log

The DMX log provides a quick way to check if the fixture is receiving DMX instructions correctly. The log displays

the start code (

STCO

), which must be 0, and the DMX values received on each control channel.

To read a value, navigate to

TEST

DMXL

and press [Enter]. Scroll to an effect channel and press [Enter] to read

the DMX value received. Look up the value’s function in the DMX protocol to see if it corresponds to the effect’s

behavior.

Quality control and service tests

The

PCB

and

FACT

menus, under

TEST

, contain tests for factory and service use. The factory effects test

(

TEST

FACT

ETST

) drives all effects at 10 percent over their maximum speed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 300 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Martin MAC 300