Martin MAC 250 ENTOUR Bedienungsanleitung PDF herunterladen (Seite 3)

MAC 250 Beam Installation Note 3

5. See Figure 3. Fasten the new front lens

mounting bracket (P/N 62420240) supplied in

the Kit to the front of the head using the four

M4 X 12 Torx 20 screws (P/N 08070710) also

supplied in the Kit. Apply a very small quantity

of Loctite to the threads before tightening the

screws.

If you reinstall the original front lens at a later

date to return the fixture to standard MAC 250

Wash configuration, re-use these Torx screws.

6. See Figure 4. Remove the four screws

(arrowed) that hold the aperture plate in place inside the front

of the head. See Figure 5. Remove the aperture plate and

install the new aperture plate with shield plate (P/N

23819530) supplied in the Kit in its place, re-using the

original four screws. The shield plate in the aperture plate

must face upwards as illustrated to protect the wiring in the

head from sunlight that might be focussed into the head by

the new front lens assembly.

If you reinstall the original front lens at a later date to return

the fixture to standard MAC 250 Wash configuration, you

must remove the new aperture plate together with the new

front lens assembly.

Figure 3

Figure 4

Figure 5

1 2 3 4 5 6 7 8

Keine Kommentare

Martin MAC 250 ENTOUR Bedienungsanleitung Seite 3