Martin ATOMIC 3000 Bedienungsanleitung PDF herunterladen (Seite 9)

Atomic 3000 user manual Lamp 9

AMP

This section describes the lamp options, the lamp power setting, and how to

replace the lamp.

The lamp is electronically regulated to prevent overheating. Lamp regulation can

be seen, for example, by the gradually decreasing intensity of the blinder effect.

LAMP POWER SETTING

The Atomic 3000 provides high and low lamp power settings. The high power

setting provides maximum flash intensity; the low power setting reduces output

by approximately 50 percent and extends lamp life. The setting is selected on pin

6 of the Mode DIP switch and applies regardless of the other switch settings.

APPROVED LAMPS

Warning: Only Martin MAX-7 or MAX-15 lamps are approved in the

Atomic 3000. Installing a lamp that is not approved may create

a safety hazard or damage the fixture!

The Atomic 3000 is supplied in two models with different lamps: the Martin

MAX-7 and MAX-15 xenon strobe lamps. The MAX-7 model will in theory

accept AC power from 90 to 250 volts, but for optimum lamp life we only

approve use with power rated from 100 to 120 volts nominal. The MAX-15

model will in theory accept AC power from 125 to 250 volts, but for optimum

light output we only approve use with power rated from 200 to 240 volts nominal.

234516

High power setting

234516

Low power setting

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Keine Kommentare

Martin ATOMIC 3000 Bedienungsanleitung Seite 9