Martin MAC 350 Entour Bedienungsanleitung PDF herunterladen (Seite 22)

22 MAC 350 Entour user manual

Stand-alone operation

WARNING! Read “Safety Information” on page 3 before installing, powering, operating or servicing

the MAC 350 Entour.

This section describes how to program and run stand-alone light shows on the MAC 350 Entour without a

DMX controller. See the SA menu under “Control menu” on page 37 for a table listing stand-alone

commands. See “Effects” on page 19 for a full description of the MAC 350 Entour’s effects.

In stand-alone operation, the MAC 350 Entour can play

up to 100 pre-programmed scenes continuously in a

loop. A MAC 350 Entour can either run a stand-alone

show independently, or scene changes can be

synchronized with other MAC 350 Entour fixtures.

About scenes

A stand-alone light show consists of a sequence of

scenes. Each scene is a particular lighting effect with

predetermined effects (color, gobo, etc.) and duration.

See Figure 7. Each scene has a dynamic part – the

fade – during which effects move to the scene’s

programmed positions, and a static part – the wait –

where effects do not change.

The duration of the fade and duration of the wait must

be programmed individually for each scene. The total

time it takes a scene to execute is the sum of the fade

and wait times.

Programming stand-alone operation

To program a scene in the current stand-alone sequence:

1. In the control panel, select SA → PROG

2. Configure the effects in the scene in the following menus:

• SHUT (shutter)

• INT (intensity)

• COL (color)

• GOBO (gobo selection)

• RGBO (gobo rotation)

• IRIS (iris)

• FOCU (focus)

• PTMA (pan/tilt macros)

• EFMA (effects macros)

• PAN and TILT (pan and tilt positions).

3. Select a fade time using FADE and a wait time using WAIT.

4. Store the scene in your stand-alone sequence as follows:

• Use the ADD command to save the current scene as a new scene at the end of the stand-alone

sequence.

• Use the INS command to save the current scene as a new scene at the start of the stand-alone

sequence.

• Use the STOR command to save changes to the current scene. Note that the STOR command

does not create a new scene. It only saves changes to a scene that has already been created using

the ADD or INS commands.

You can manage the scenes you have created using the NEXT, PREV, DEL and CLR commands.

You can preview the stand-alone sequence using the VIEW command.

Fade

Wait

Fade

Figure 7: Scene timing

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 350 Entour Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Martin MAC 350 Entour