Martin DMX 5.3 Splitter Bedienungsanleitung PDF herunterladen (Seite 26)

26 Stagebar 2 user manual

Troubleshooting

Problem Probable cause(s) Remedy

Fixture is completely dead.

No power to fixture. Check power and connections.

Primary fuse blown (located in

fuseholder on rear panel).

Isolate fixture from power. Check fuse and

replace.

Fixture works normally but

other fixtures connected to

power output on rear panel

are completely dead.

Power output circuit is defective (may

have been overloaded).

Contact Martin Service for assistance.

One or more fixtures

responds incorrectly to DMX

control or does not respond

at all.

Fault on DMX link.

Inspect connections and cables. Correct poor

connections. Repair or replace damaged

cables.

Incorrect fixture addressing.

Check fixture is set to correct DMX mode.

Check number of channels required by

fixture’s DMX mode and check fixture

addresses.

Fixture defective.

Have faulty fixture serviced by Martin service

technician.

Other device on DMX link defective.

Bypass devices on DMX link until the faulty

device has been identified.

Have faulty device tested and serviced by

Martin service technician or device supplier.

LEDs cut out intermittently. Fixture is too hot.

Ensure free airflow around air vents.

Clean fans and vents.

Check that ambient temperature does not

exceed maximum permitted level.

Contact Martin for service.

LCD display dead when

fixture is connected to

power.

Fixture software is corrupted.

Contact Martin for assistance with boot mode

software upload.

LCD display dead when

fixture is not connected to

power.

Onboard battery flat. Connect to AC power to recharge battery.

Battery defective or at end of service life. Contact Martin for replacement.

Table 3: Troubleshooting

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin DMX 5.3 Splitter Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern