Martin DMX 5.3 Splitter Bedienungsanleitung PDF herunterladen (Seite 15)

Operation 15

Operation

Once the Stagebar 2 is connected and set up as described earlier in this manual, adjust color and intensity

using the DMX controller following the applicable DMX protocol (see page 21).

Color control

See “Color control mode” on page 12 for a description of RGB, RGBAW, HSI and HSIC modes.

RGBAW is a ‘raw’ (i.e. uncalibrated) control mode. If the Stagebar 2 is set to RGBAW mode and you require

precisely matched, even color, it may be necessary to compensate for small differences in LED color

rendition by fine-tuning LED intensity on individual pixels at the controller. If this is inconvenient, switching to

one of the other color control modes will give management of color mixing to the fixture software and deploy

factory settings, thus restoring color evenness.

All five LED colors are active in all color control modes.

Stand-alone operation

In stand-alone operation, the Stagebar 2 can be programmed to run two types of display without the need

for a DMX controller:

• A static color that you select by adjusting the intensity of the RGBAW pixels.

• Dynamic sequences of RGB, RGBAW or pastel colors that you can set to run at fast, medium or slow

speed. Colors cross-fade (this means that one color fades smoothly into the next with an overlap) and

each sequence repeats in a loop.

Programming stand-alone operation

Stand-alone operation is programmed in the STAND ALONE → sa setup control menu.

When stand-alone operation has been programmed, the Stagebar 2 runs the selected stand-alone display

whenever it is powered on.

DMX override

If a Stagebar 2 receives a DMX signal during stand-alone operation, it stops its stand-alone display and

obeys DMX commands. If the DMX signal is no longer received, the Stagebar 2 resumes stand-alone

operation after a delay of approximately 5 seconds.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Keine Kommentare

Martin DMX 5.3 Splitter Bedienungsanleitung Seite 15