Martin MiniMAC Maestro Bedienungsanleitung PDF herunterladen (Seite 28)

Stand-alone operation

6 Study “About scene timing” on page 29, ensuring that you understand it and then use

the remote control to program scenes into the fixture. See “Remote control

commands” on page 32.

To setup multiple fixtures for IR Stand-Alone operation

Important! Do not terminate the link in IR Mode.

Note Some early versions of the MiniMAC Maestro receiver module

have the restriction that they only support IR operation for a

single fixture. These modules can be easily identified as they

are black. The newer version that supports multiple fixtures is

grey.

1 Select a fixture to be the master. For convenience, select an end fixture close to a

good programming spot. Insert the receiver module into the master’s serial data In

socket. Position the sensor arm as desired but avoid turning it more than necessary.

2 From the control panel of the master fixture, scroll to

Pro in the main menu, press

[enter], and scroll to

rCS (remote control, send). Press [enter] to activate the

setting. Select

Adr from the main menu and press [enter]. Select an address from 0

to 9 and press [enter].

3 Stand 2 meters (6 ft.) away from the fixture, point the remote control at the receiver,

and press the lamp power button. If there is no response, try the ID button. If there is

still no response, reverse the sensor head by rotating the sensor arm 180° and folding

it over.

4 Plug a data cable into the OUT socket of the master fixture and the IN socket of the

next fixture. Repeat as required to connect up to 10 fixtures. DO NOT place a

termination plug in the output of the last fixture.

5 On each fixture except the master, scroll to

Pro in the main menu, press [enter],

and scroll to

rCr (remote control, receive). Press [enter] to activate the setting.

Select

Adr from the main menu and press [enter]. Select an unused address from 0

to 9 and press [enter]. (Each fixture must have a unique address: they may share an

address, though, if you always want them to behave identically.)

6 (Optional) Set the gobo blackout, display, and automatic lamp-on personality options

as described on page 19.

7 Study “About scene timing” on page 29, ensuring that you understand it and then use

the remote control to program scenes into each fixture. See “Remote control

commands” on page 32.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Keine Kommentare

Martin MiniMAC Maestro Bedienungsanleitung Seite 28