Martin MiniMAC Maestro Bedienungsanleitung PDF herunterladen (Seite 20)

Control panel

READOUTS

The MiniMAC Maestro provides readouts to track usage, maintenance intervals,

lamp life, and software version. Values from 1000 to 9999 are automatically

scrolled and counters roll over to 0 when they reach 10,000.

To display or reset a readout

1Scroll to Inf in the main menu, press [enter] and scroll to the desired readout.

Press [enter] and scroll to the desired option. Press [enter] to display the information.

2 (Optional) To reset a counter, press [up] until the readout displays

TEST PROGRAMS

Test sequence: The test sequence allows you to check all effects quickly. At the end

of the test cycle, effects return to their home position briefly before the test repeats.

To run the test, navigate to

tSt / tSE / run and press [enter]. To stop the test,

press [menu].

PCb: For service use only. Executing this test with motors connected may cause

damage to the circuit board.

To test DMX control values

1 On the controller, program a set of commands for the fixture.

2Scroll to

tSt in the main menu, press [enter] and scroll to LOg. Press [enter].

3 Press [enter] to display the start code. The start code must be 0. Press [menu].

4 Scroll through the effects and press [enter] to display the DMX values received.

Compare the values with the DMX protocol.

UPLOAD MODE

Software upload mode is normally engaged automatically. Use this option only if

automatic upload fails. See “Installing software” on page 43.

MANUAL CONTROL

The manual control menu (Ctr) provides limited manual operation and is used to

program and execute scenes as in Stand-alone mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Keine Kommentare

Martin MiniMAC Maestro Bedienungsanleitung Seite 20