Martin Ego 01 Bedienungsanleitung

Ego 01Ego 02Ego 03Logo Projectoruser manual

10 Ego user manualLINKING MULTIPLE EGOS FOR SIMULTANEOUS CONTROLYou can link multiple Egos, of any type, using speaker cables with stereo mini-jack c

Operation 11OPERATION4To achieve optimal results the use of smoke effects together with your Ego is recommended.The lamp turns on as soon as power is

12 Ego user manualThe separately orderable remote control unit can be used to link multiple Egos and allows the simultaneous adjustment of their dynam

Operation 134 Pull the tab away from the fixture base to select the textured glass, push it towards the fixture to select the etched gobo position.5 T

14 Ego user manualBASIC SERVICE5This chapter describes the maintenance procedures that you can perform yourself:• Cleaning (see below)• Lamp maintenan

Basic service 151 Disconnect the fixture from power and allow the components to cool completely. 2 Remove the fixture cover. You may want to remove th

16 Ego user manual3 If replacing a lamp, grasp the old lamp by the reflector and pull it out of the holder. Then pull the socket off the lamp. Do not

Basic service 175 Replace the fixture cover and tighten the access screws, taking care not to trap any loose wires.GOBO REPLACEMENT OR REMOVAL (EGO 2

18 Ego user manualTROUBLESHOOTING6problem probable cause(s) suggested remedyNo light No power to the fixture Check connectionsBlown fuse If fan does n

Specifications 19SPECIFICATIONSAPHYSICALSize without standard bracket (L x W x H) 305 x 324 x 150 mm (12 x 12.8 x 5.9 in)Weight. . . . . . . . . . .

Measurements are expressed in millimeters.305324248150© 2002-2004 Martin Professional A/S, Denmark.All rights reserved. No part of this manual may b

3CONTENTSIntroduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4Ego 01 / Logo Projector . . . . . . . . . . .

4 Ego user manualINTRODUCTION1Thank you for selecting a Martin Ego. The Ego series features 250 watt flower effects with sharp projection quality opti

Introduction 5 EGO 03The Ego 03 is a kaleidoscopic effect with a range of gobo and color combinations on a single effect wheel that are projected onto

6 Ego user manual• Provide a minimum clearance of 0.1 meters (4 inches) around fans and air vents. • Replace the lamp if it becomes defective or worn

AC power 7AC POWER2The Ego has an auto-ranging power supply that can operate in the following voltage ranges at 50-60 Hz:• 90-130 volts• 200-250 volts

8 Ego user manualINSTALLATION3 MOUNTINGEgo fixtures can be flown using a clamp (available from your Martin dealer), or fastened to a horizontal or ver

Installation 9securely to the fixture’s mounting bracket with a grade 8.8 (minimum) M12 bolt and lock nut, or as recommended by the clamp manufacturer