Martin RoboColor III Bedienungsanleitung PDF herunterladen (Seite 4)

4 Setting Up RoboColor III

Check voltage setting

Important! The voltage setting of the heads must match your local AC mains

supply.

The RoboColor III head is supplied in a 50 Hz or 60 Hz version. It is not possible

to rewire from 50 Hz to 60 Hz, or vice versa.

• The factory setting is printed on a label on the back of the head. Check the

setting against the table below and rewire if necessary, following the

instructions on page 15.

PREPARING THE CONTROLLER

Install a mains plug

Warning! For protection from dangerous electric shock, the fixture must

be grounded (earthed). The AC mains supply shall be have a

fuse or circuit breaker, and ground-fault protection.

The controller may be supplied without a plug on the mains cable. You will have

to fit a plug that conforms to your local mains outlet before you can connect the

unit to AC power. The double insulated mains cable contains three wires.

1 Connect the BROWN wire to the LIVE pin.

2 Connect the BLUE wire to the NEUTRAL pin.

3 Connect the YELLOW/GREEN wire to the EARTH pin.

50 Hz Model 60 Hz Model

Mains supply Ballast tapping Mains supply Ballast tapping

210V - 235V 230V 200V - 215V 210V

235V - 245V 240V 215V - 225V 220V

245V - 255V 250V 225V - 235V 230V

Wire Pin Marking Screw color (US)

brown live “L” yellow or brass

blue neutral “N” silver

yellow/green ground green

1 2 3 4 5 6 7 8 9 ... 23 24

Keine Kommentare

Martin RoboColor III Bedienungsanleitung Seite 4