Martin RoboColor III Bedienungsanleitung PDF herunterladen (Seite 15)

User Manual Service and Maintenance 15

VOLTAGE SETTINGS

It is essential that the voltage and frequency setting of your RoboColor III system

matches the mains supply. Otherwise damage may occur.

Warning! Disconnect the fixture from AC power before removing any cover.

To change the controller voltage setting

1 Access the transformer by removing the top cover.

2 On the transformer, move the BROWN wire to the correct voltage terminal. If

the mains voltage is between 210 and 240 volt use the 230 volt tap. If the

voltage is between 240 and 255 volt then use the 250 volt tap.

3 Re-assemble the unit.

To change the head voltage setting

1 Remove 6 screws from the back of the unit, as shown, and carefully withdraw

the entire rear assembly.

230V

250V

NEUTRAL.

Do NOT remove

BLUE wire.

Transformer

First, remove

these 6 screws.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Keine Kommentare

Martin RoboColor III Bedienungsanleitung Seite 15