Martin EFX800 Bedienungsanleitung PDF herunterladen (Seite 7)

Introduction 7

• Do not modify the fixture or install other than genuine Martin parts.

Preventing injuries due to falls

• When suspending the fixture above ground level, verify that the

structure can hold at least 10 times the weight of all installed devices.

• Ensure that all external covers and rigging hardware are securely

fastened and use an approved means of secondary attachment such as

a safety cable.

• Block access below the work area and work from a stable platform

whenever installing or removing the fixture.

Discharge lamp safety

• EFX600™, EFX700™ and EFX800™ fixtures use a discharge lamp. If

the quartz envelope of a discharge lamp is broken, the lamp releases a

small quantity of mercury and other toxic gases. If a discharge lamp

explodes in a confined area, ventilate thoroughly and evacuate if

necessary. Wear non-porous safety gloves when handling a broken

discharge lamp. Treat broken or used discharge lamps and used safety

gloves as hazardous waste and send to a specialist for disposal.

Unpacking

Important! Do not lift or carry a fixture by holding the motor housing (if

fitted) on the front of the fixture. It is not designed for this

purpose. You could injure yourself or others, and you could

cause damage that is not covered by the product guarantee.

The packing material is carefully designed to protect the fixture during

shipment - always use it to transport the fixture.

Mania EFX™ fixtures are supplied with the following items:

• 3-wire power cable(s) with IEC power input connector.

• 5m (16.4 ft.) DMX cable.

• Mounting plate (installed).

• EFX500 only: 250 watt halogen lamp (installed).

• EFX600, EFX700 and EFX800: 150 watt discharge lamp (this is

supplied separately to avoid damage during shipping and must be

installed before use – see “Installing a discharge lamp” on page 30).

• EFX800 only: paddlewheel shield for use during transport (installed).

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Keine Kommentare

Martin EFX800 Bedienungsanleitung Seite 7