Martin MAC 250+ Bedienungsanleitung PDF herunterladen (Seite 32)

32 MAC 250 Wash

Error messages

Display readout Appears if... What to do



...there is no communication between

the control panel and motherboard

(this display appears briefly when

switching on the fixture).

• Check fuses.

• Check cable between control panel

and motherboard.

• Reinstall software.

• Contact service technician.



...the EEPROM memory cannot be

read.

• Contact service technician.



...a display programming error occurs

due to contaminated upload data.

• Repeat upload procedure.

• Contact service technician if problem

persists.



...there is a drive current error. • Contact service technician.



...there is a real-time clock error. • Contact service technician.



...the magnetic-indexing circuit

malfunctions (e.g. sensor defective

or magnet missing). After a time-out,

the color wheel stops in a random

position

• Contact service technician.



...there is a cyan feedback error. • Contact service technician.



...there is a magenta feedback error. • Contact service technician.



...there is a yellow feedback error. • Contact service technician.



...there is a pan error and the sensor

cannot find the pan index point. After

a time-out, the fixture stops in a

random position.

• Contact service technician.



...there is a tilt error and the sensor

cannot find the tilt index point. After a

time-out, the fixture stops in a

random position.

• Contact service technician.



...there is a pan/tilt feedback error. • Contact service technician.



...there is a pan feedback error. • Contact service technician.



...there is a tilt feedback error. • Contact service technician.



...the lamp is too hot to restrike.

• Allow lamp to cool (typically for about

8 minutes).



...the lamp cannot be struck. • Replace lamp.



...a light sensor error occurs. • Contact service technician.



...the head temperature cutoff is

activated.

• Allow fixture to cool.

• Clean fans, air filter and air vents.

• Contact service technician if problem

persists.



...there is a short-circuit and the lamp

strikes without a command.

• Contact service technician.



...the head temperature sensor

malfunctions.

• Contact service technician.



...the base unit temperature sensor

malfunctions.

• Contact service technician.



...a CPU error occurs (NIE =

non-maskable interrupt error) .

• Reset fixture

• Upload new software

• Contact service technician

Table 6: Error messages

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin MAC 250+ Bedienungsanleitung Seite 32

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Martin MAC 250+