Martin MAC 250 ENTOUR Bedienungsanleitung PDF herunterladen (Seite 23)

Optical configuration 23

2 Remove the top cover. The top and bottom cover look the same, but the top cover is found by checking if

the text on the back of the head is oriented correctly (top) or not (bottom).Remove the top cover of the

fixture head using a flathead screwdriver to loosen the four quarter-turn screws. The top and bottom cover

look the same, but the top cover is found by checking if the text on the back of the head is oriented correctly

(top) or not (bottom) as illustrated here.

3 Using a flathead screwdriver, remove the two retaining plates (only one - at position A - is illustrated here)

holding the prism module in place. Disconnect the cables (at positions marked B) from the PCBs on the

prism module.

4 Lift the prism module out of the fixture.

Minimum

dist

ance to flammMinimum

dist

ance to flamm

Minimum

dist

ance to illumina

Maximum

ambient te

Exterior surface to

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Keine Kommentare

Martin MAC 250 ENTOUR Bedienungsanleitung Seite 23