Martin DMX 5.3 SplitterMartin RDM 5.5 Splitteruser manualTMTM
10 Martin DMX 5.3 and RDM 5.5 Splitters user manualMartin Splitters also reduce signal reflections that can be a problem in larger installations or on
Physical installation 11Physical installationMounting in a rigBoth the DMX 5.3 Splitter and the RDM 5.5 Splitter can be flown in a rig. To install the
12 Martin DMX 5.3 and RDM 5.5 Splitters user manualWarning! Do not fasten screws with a thread length of more than 4 mm (0.15 in.) into the ends of ei
AC power 13AC powerWarning! For protection from dangerous electric shock, the device must be grounded (earthed). The local AC power source must have b
14 Martin DMX 5.3 and RDM 5.5 Splitters user manualTable 1 shows some pin identification schemes. Consult a qualified electrician if you have any doub
AC power 155. Insert each of the wire ends into the appropriate terminal (see illustration on right and Table 1 above) and fasten using a small flathe
16 Martin DMX 5.3 and RDM 5.5 Splitters user manualData connections and setupThe Martin DMX 5.3 Splitter uses 3-pin XLR and the Martin RDM 5.5 Splitte
Data connections and setup 17The LED under the termination button lights when DMX termination is applied.Data outputThe Splitter’s out 1 - out 5 socke
18 Martin DMX 5.3 and RDM 5.5 Splitters user manualTo solve this problem, the RDM 5.5 Splitter can be used as a data signal filter. If the dmx only bu
Operation 19OperationStatus LEDsOperation can be monitored using the status LEDs on the front of the Martin Splitters:Martin DMX 5.3 SplitterMartin RD
DimensionsAll dimensions are in millimetersMartin RDM 5.5 Splitter illustrated. Martin DMX 5.3 Splitter has same dimensions220mm124.5mm45mm© 2011 Mart
20 Martin DMX 5.3 and RDM 5.5 Splitters user manualFirmware/software uploads when using SplittersMartin products that support firmware/software upload
Service 21ServiceWarning! There are no user-serviceable parts inside the device. Refer all service apart from cleaning to Martin Professional or its a
22 Martin DMX 5.3 and RDM 5.5 Splitters user manual• A PC running a Windows version supported by the Martin Uploader application.• A Martin USB Duo™ D
Block diagrams 23Block diagramsMartin DMX 5.3 SplitterMartin RDM 5.5 Splitter
24 Martin DMX 5.3 and RDM 5.5 Splitters user manualSpecificationsPhysicalDepth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Typical power consumption110 V, 60 Hz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 W240 V, 50
Disposing of this productMartin Professional products are supplied in compliance with Directive 2002/96/EC of the European Parliament and of the Counc
www.martin.com • Olof Palmes Allé 18 • 8200 Aarhus N • DenmarkTel: +45 8740 0000 • Fax +45 8740 0010
ContentsDimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2Safety information . . . . . . . . . . .
4 Martin DMX 5.3 and RDM 5.5 Splitters user manualSafety informationThe following symbols are used to identify important safety information in this ma
Safety information 5• Connect the device to AC power using either the supplied power input cable (DMX 5.3 Splitter only) or via 3-conductor cable that
6 Martin DMX 5.3 and RDM 5.5 Splitters user manualPROTECTION FROM INJURY DUE TO FALLS• When suspending the device overhead, ensure that the supporting
Introduction 7IntroductionThank you for selecting a Martin Professional™ DMX/RDM Splitter/Amplifier. This range consists of two products:• The Martin
8 Martin DMX 5.3 and RDM 5.5 Splitters user manualUsing for the first time Before applying power to the device: • Carefully review ”Safety information
Introduction 9AmplificationMartin Splitters amplify the DMX or DMX/RDM signal, allowing the data link to be extended by max. 500 m (1740 ft.) using AW
Kommentare zu diesen Handbüchern